DEWALT DPG82-11 Concealer Clear Anti-Fog Dual Mold Safety Goggle ReviewsConstruction Tools News]

[wpramazon asin=”B01A12J3GI”]

3 Responses to DEWALT DPG82-11 Concealer Clear Anti-Fog Dual Mold Safety Goggle ReviewsConstruction Tools News]

  • jirobinson13 says:
    233 of 238 people found the following review helpful
    5.0 out of 5 stars
    Fantastic Googles, April 7, 2014
    By 

    Verified Purchase(What’s this?)
    These are so much better than the 99 cent glasses you get at typical hardware stores. They provide protection against air particles such as dust and spray paint. I have used mine a lot and have got them extremely sweaty and gross with almost no noticed wear on the plastic or soft foam. They are quite large but should fit most faces.

  • Summer says:
    76 of 78 people found the following review helpful
    5.0 out of 5 stars
    Glasses, January 1, 2017
    By 
    Summer (Oklahoma) –

    Verified Purchase(What’s this?)
    This review is from: DEWALT DPG82-11 Concealer Clear Anti-Fog Dual Mold Safety Goggle (Tools & Home Improvement)
    Needed goggles that would go over glasses. My friend recommended these. I was skeptical. First use they did the job with no complaints. Fit perfectly over my glasses with no gaps. I sanded some foam and worbla. None of it got under the goggles. Extremely happy, especially for the price.

  • TMC LLC. says:
    293 of 312 people found the following review helpful
    2.0 out of 5 stars
    Not Recommended for Use While Sanding, June 30, 2015
    By 
    TMC LLC. (Massachusetts) –

    Verified Purchase(What’s this?)
    I purchased these goggles to use while sanding finish off of deck rails. On the plus side, they fit well over my glasses. However, they fogged up almost immediately and I had to keep taking them off every few minutes to wipe the condensation from the inside so that I could see. What was most troubling is that the wood and paint dust from the sanding went right into the tiny vents around the top & bottom of the goggles and into my eyes – days later my eyes are still stinging. The attached image shows some of the dust caked inside the vented top section of the goggles.

Leave a Reply

Your email address will not be published. Required fields are marked *